Step-by-Step Guide to Brick Border Edging

Brick Border Edging

One of the projects that I (when I say I, I actually mean my far more practical other half) want to tackle this summer is the edge between the lawn and the borders. 

Our strimmer seems to run out of strimming
line roughly every two minutes and I end up
on my hands and knees using our blunt garden
shears to hack at the edge of the lawn.

With sunken bricks, you can just mow straight over them and the borders look tidy and stay contained. Overall, this gives a really neat finish to the garden.

Seasonal Garden IdeasSeasonal Garden Ideas

Our fab gardening book,
Seasonal Garden Ideas,
shows you how to do this
in 5 simple steps.
I think I will leave it open
on the coffee table until
someone gets the hint!

NOW AVAILABLE £3.99!

 

Instructions

You can put in brick edging at any time of year, but it’s better to choose a dry day for it.

The time it takes will depend on the length of run.

Equipment

  • Engineering bricks.
  • Sand.
  • Ready-mixed mortar.
  • Spade and bricklayer’s trowel.
  • Watering can or bucket for water.
  • Wheelbarrow or board for mixing mortar.

1 The bricks can be laid on a 12.5cm (5in) footing of sand. Assuming your bricks are 7.5cm (3in) thick, you need to dig a trench 20cm (8in) deep. Start by digging the trench along the full length of the border, making it slightly wider than the length of brick you are using.

2 Line the entire length of the trench with a 12.5cm (5in) deep layer of sand, tamping it down very firmly.

3 Make up the mortar according to the manufacturer’s instructions, using either a wheelbarrow or a board for mixing. Lay a stretch of mortar on the sand at the start of the trench and set the first bricks into it, mortaring neatly between each brick.

4 Continue in this way for the length of the trench, allowing for any curvature along the way by inserting a slightly wider band of mortar between the bricks on the lawn side of the edging. The brick edging should be flush with the grass edge or very slightly below it.

5 Leave the mortar to dry and set before running a mower across the edging.

Tip
Check that all the bricks you use are sound and whole – the wheels of a mower going over them can give quite a battering, which will soon destroy a damaged brick.

Notes
If you prefer you can use concrete instead of sand for the footing – it will be even stronger. Use ready-mixed concrete and follow the manufacturer’s instructions for its use.

Aftercare
Lever up and replace any cracked or broken bricks as soon as you can after spotting them. Once there is a break in one brick, those adjacent to it will also start to crumble and disintegrate. Brush dirt, leaves and debris off the brick edging to keep it looking good.

#gardening

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: